If you want to remove your electric toothbrush from its charging dock, you’ll need to unscrew the two metal bolts holding it in place.
The toothbrush will then fall out of the charging dock.
First, you need to open the charging cord and pull it out.
Next, you’re going to need to remove the metal bolts.
You’ll need a pair of pliers and a pair, or a small flathead screwdriver.
If you’re using a Phillips head screwdriver, you can also use a small, round, square or diamond shaped screwdriver to get them out.
If the screws aren’t already on the charging cable, you may need to get the cable out with a soldering iron or a flathead.
When you remove the toothbrush bolts, there are three metal pins that hold the battery in place, and you’ll also need a piece of wire to pull the toothpaste tube out of it.
There’s also a large, flat piece of metal on the outside of the tooth brush, called a bolt that is also held in place by the bolts.
First thing to do is remove the bolts from the charging port.
The bolt itself is made of anodized aluminum, but the bolt that holds the battery is made from anodize.
If your toothbrush isn’t charging right now, the battery will be loose.
First off, take a small screwdriver and try to pry the battery out with it.
If that doesn’t work, it could be the batteries charging in the wrong direction.
Then, you should remove the battery.
You can also remove the charging coil from the toothbrushes battery compartment.
You don’t have to take the charging battery out to be sure, but it is good practice to do so.
The charging coil will be visible on the top of the battery compartment and you can see where it sits when the toothpastes are removed.
To remove the bolt, first you need a small tool with a bit of force to pull it free.
This will pull the charging bolt out.
Once the bolt is free, pull it back out, and try again.
If it still doesn’t get the job done, you might want to use a pair or three pliers.
Next you’re ready to remove some of the plastic that surrounds the battery connector.
To do this, you want something like a wire stripper, or an old toothbrush clip.
You might need to use your fingernail or a razor blade to push the plastic into the metal connector.
If this isn’t possible, use a hammer or a knife to push it out with some force.
The metal connector will come loose, so you need the cable to be released.
You will need to pull a small cable out of a connector.
There are a few ways to do this.
First you might need a drill press or a power drill, or you can use a screwdriver or a screw driver and a wrench to pull out the cable.
If these tools don’t work you can get a pair with a little bit of pressure.
Next use a large flathead or diamond blade to cut out a small hole in the plastic connector.
Next the tooth paste should come out.
Make sure you do this carefully, as it will remove some plastic and possibly make the tooth brushes battery easier to remove.
You could also use some sandpaper to wipe away any dirt from the plastic.
The last thing you’ll want to do with the tooth brushes charging port is to put some water in the charging tube.
To put some liquid in, you will need a little piece of pipe that’s long enough to go into the charging connector.
You should be able to put a little water in there and then you can remove the plug.
If all this wasn’t clear enough, here’s a video on how to put water into a charging dock: